10 things to know before you buy Measuring tools
Practical buying checks for measuring tools, with the jargon explained.
-
Select accuracy for the job Furniture and fitting work may need millimetre consistency, while rough landscaping rarely does. Check the stated tolerance, meaning the permitted measurement error, rather than assuming a digital display is automatically more accurate.
-
Tape width controls stand-out A broad, curved tape can extend farther unsupported, making long solo measurements easier, but creates a bulkier case. Narrow tapes are lighter and usually sufficient for close indoor work.
-
Understand the moving end hook A tape hook slides by its own thickness so inside and outside measurements start from the same zero point. It should move freely by that small amount; a bent hook or elongated rivet holes produce repeatable errors.
-
Use the right spirit-level length Long levels average out small surface bumps and are best for cabinets and door frames. Short levels fit confined spaces but can show a local surface as level while the whole installation is not.
-
Check level-vial tolerance Quality levels state accuracy in millimetres per metre, with a smaller figure indicating less permitted slope. Confirm whether the rating applies in both normal and inverted positions if overhead work is planned.
-
Laser colour affects visibility, not accuracy Green beams appear brighter to human eyes than red beams at the same power, especially indoors, but consume more battery. Range and levelling tolerance determine accuracy; colour mainly affects how easily the line can be seen.
-
Self-levelling has a limited range A self-levelling laser corrects only a few degrees of base tilt and should flash or stop when outside that range. A lock protects the pendulum during transport and permits deliberate angled lines.
-
Distance meters need a clear target Laser distance meters calculate length from reflected light and may struggle on dark, glossy or sunlit surfaces. Check whether the quoted range is realistic outdoors and whether a target plate or viewfinder is supported.
-
Squares must actually be square Test a try square by drawing a line, flipping the tool and comparing a second line from the same point. A fixed square that fails this test cannot be adjusted and will transfer its error to every cut.
-
Readable markings save mistakes Look for etched or deeply printed metric markings with clear millimetres, viewed from the working side. Mixed imperial and metric scales can be useful, but crowded markings increase the chance of reading the wrong row.
Browse more in Hand tools