10 things to know before you buy Heat pumps

Practical buying checks for heat pumps, with the jargon explained.

  1. Begin with room-by-room heat loss A proper design calculates heat escaping from each room at the local winter design temperature. Rules based only on floor area can undersize the unit or hide radiators and pipework that need improvement.

  2. Flow temperature drives efficiency Heat pumps work most efficiently when sending cooler water through sufficiently large radiators or underfloor heating. Ask for the design flow temperature and predicted seasonal performance, not only the unit’s maximum temperature.

  3. COP and SCOP are not the same COP is efficiency at one test condition, while SCOP estimates performance across a heating season. Compare SCOP at the proposed water temperature and climate, because a favourable single-point COP can misrepresent annual electricity use.

  4. Check output in cold weather Air-source output and efficiency fall as outdoor temperature drops, just when the building needs most heat. The design should show available capacity at the chosen winter temperature and explain any backup heater use.

  5. Hot water needs separate planning Most heat-pump homes require a cylinder, and reheating it at efficient temperatures takes longer than with a boiler. Size storage for household use and check how periodic higher-temperature hygiene cycles are provided.

  6. Outdoor-unit position affects neighbours Fan and compressor sound varies with load and includes tonal characteristics not captured by one headline number. Review the calculated sound at nearby windows, airflow clearances, defrost drainage and access for servicing.

  7. Controls should favour steady running Heat pumps usually perform best maintaining a stable temperature with weather compensation, which adjusts water temperature to outdoor conditions. Boiler-style short heating bursts and aggressive thermostat setbacks can reduce efficiency.

  8. Electrical capacity may need work The installer should check the consumer unit, supply capacity and any network-operator notification or approval. Include immersion heaters and electrical backup in the maximum-demand assessment, not only the compressor rating.

  9. Use an accredited system designer For grant eligibility and consumer protection, check current MCS requirements and the installer’s certification for the proposed technology. Demand the full design, emitter schedule and commissioning data rather than accepting a product-only quotation.

  10. Compare lifetime system costs Include radiator changes, cylinder, electrical work, maintenance and likely electricity use alongside the unit price. A cheaper installation designed for high flow temperatures can cost more to operate throughout its life.