10 things to know before you buy Air compressors

Practical buying checks for air compressors, with the jargon explained.

  1. Delivered air matters more than displacement Compare free air delivery, the usable output at a stated pressure, with each tool’s consumption. Pump displacement is a larger theoretical intake figure and can make an undersized compressor appear adequate.

  2. Allow for tool duty cycle Sprayers, sanders and grinders use air continuously, while nailers take brief bursts. The compressor should meet average demand without exceeding its duty cycle, meaning the permitted proportion of time the pump may run.

  3. Tank size does not create more air A larger receiver smooths pressure and gives short reserve time but eventually empties if pump output is below demand. It also adds weight, drainage volume and inspection responsibility.

  4. Oil-free and lubricated pumps trade benefits Oil-free units reduce maintenance and avoid oil carry-over for decorating, but can be noisy and wear faster under heavy duty. Lubricated pumps often run more quietly and need oil checks plus suitable air filtration.

  5. Noise can dominate workshop use Direct-drive compressors may exceed comfortable indoor levels, while slow-running quiet models cost more but make communication possible. Compare decibels at the same distance and wear hearing protection where exposure requires it.

  6. Pressure and connectors must match Regulate outlet pressure to the tool’s rating and confirm hose bore, length and quick-coupler type can deliver the required flow. Narrow coiled hoses and mixed connector standards cause pressure loss and frustrating leaks.

  7. Moisture needs planned removal Compressed air cools in the receiver and releases water, which rusts tanks, spoils paint and damages tools. Drain the receiver as instructed and add correctly placed separators or dryers for spray finishing.

  8. Inspect the receiver and safety valve The pressure vessel should have a traceable rating, working drain, pressure gauge and untouched relief valve. Follow inspection requirements for the installation and never repair a corroded tank by welding or sealing it.

  9. Electrical starting load can be high A motor may draw several times its running current during startup. Check plug and supply requirements, avoid undersized extension leads and ensure the pressure switch unloads correctly before repeated starts.

  10. Compressed air is not for cleaning people Never direct air at skin, clothing or eyes; it can inject air and drive debris into tissue. Use guarded low-pressure cleaning nozzles where allowed, extraction for dust, and proper inflation equipment with a gauge.